HWH® SYSTEM-SPECIFIC OPERATION

 LEVELING SYSTEMS – 725 SERIES

“HOW TO OPERATE”

(Filename:  MI16_OP_LESY01.DOC  |  Revised:  14FEB17)

 

 

 

 

 

 

! WARNINGS !

 

ALL Newmar Operator Manuals

 

 

 

 

ml54800_newmar.html

 

Auto Level:

1. Set the park brake.

2. Ignition key must be in the ACC or ON position.

3. Push the AUTO LEVEL button one time. The AUTO LEVEL light will flash.

4. System will auto level, stabilize and shut off.

5. The individual red jack down warning light will come on as its jack starts to extend.

6. Ignition key can be turned to OFF.

 

Auto Store:

1. Park brake does not have to be set.

2. Ignition key must be in the ACC or ON position. (Or start the engine)

3. Push the STORE button. The STORE light will flash.

4. System will store the jacks and the suspension will start to return to ride height.

5. The STORE light will turn off approximately one (1) minute after the last red jack down warning light goes out.

6. The ignition key can be turned to OFF after the STORE light stops flashing.

 

Manual Leveling:

1. Set the park brake.

2. Ignition key must be in the ACC or ON position.

3. Push the DUMP button. Wait until the vehicle stops lowering.

4. Push an UP arrow button corresponding to a lit yellow level light. Hold the UP arrow button on until the corresponding yellow level light goes out. If two yellow level lights are lit, push the side UP arrow button until that side yellow level light is out. Then push the front or rear UP arrow button if that yellow level light is still lit. Hold that UP arrow button on until the corresponding yellow level light goes out.

5. The individual red jack down warning light will come on as its jack starts to extend.

6. When all four yellow level lights are off, if both front jacks are not on the ground, push the front UP arrow button until both front jacks are on the ground and lifting very slightly.

7. If both rear jacks are not on the ground, push the rear UP arrow button until both rear jacks are on the ground and lifting very slightly.

8. The ignition key can now be turned to OFF

 

Manual Retract

1. The park brake does not have to be set.

2. Ignition key must be in the ACC or ON position. (or start the engine)

3. Push and hold the front DOWN arrow button. Release the button several seconds after both front red jack down warning lights are off.

3. Push and hold the rear DOWN arrow button. Release the button several seconds after both rear red jack down warning lights are off.

4. The ignition key can now be turned to OFF.

Note: The vehicle will not return to ride height until the park brake is released or the DUMP button is pushed. The ignition must be in the ON or ACC position for the vehicle to return to ride height.